Dedicated Micros ©2006
62
DS2 Network Guide
The typical process for SMS messaging is:
The unit will send a message to the mobile phone. This can be on receipt of an alarm or
manually initiated.
The operator then has the option to send a message back to the unit or log onto the unit using
the web interface or Viewer software.
If the Operator is remote they can send a message back to the unit to action the Server to
send an alarm message to a remote viewing application. The unit will send a message to the remote
monitoring station which includes the information in the text it has received.
The remote station can then access the unit to acknowledge and action the alarm.
To enable the serial port for the SMS feature:
1. Select System -> Serial Ports & Telemetry.
2. Using the drop down list on the associated Communication port (Serial 1 if dial on alarm
is enabled) select PPP.
3. Select the relevant modem from the Modem/TA drop down list, if your modem is not
supported then you will need to add the modem to the modem.ini le.
4. The serial standard settings for the selected modem will automatically be allocated,
however if this is incorrect you can change these for:
Baud rate, Parity, Data bits, Stop bits, Flow control.
5. Remember to save the conguration by selecting Save Settings!
To edit the modem.ini le for modems which are not identied in the drop down list of
supported modems:
1. Using an FTP client application connect to the unit.
2. Locate the \etc directory and expand.
3. Locate the modem.ini le.
4. Highlight and press the right mouse button, select edit.
5. Enter the information for the GSM Modem being used, an example of the information is
shown below:
[N30HSCSD]
name=Nokia30HSCSD
reset=AT&F
init=ATE0&C1&D2S0=1+CMGF=1;+CBST=16,0,1
save=AT&W
negate_dtr=0
To congure the SMS information to allow a text message to be transmitted on receipt
of an alarm:
1. Select Network -> SMS-Setup.
2. Enter the GSM destination number of the mobile phone, this should be entered in
international format including the country code.
3. It is possible to make the unit into an SMS Server by enabling the SMS Server option. If
this has been enabled then you need to enter the destination URL or IP address of the
unit. This will allow the message to be sent from a unit to a unit.
4. Enable the operations that are applicable to your application; Report startup, alarm,
camera fail, and VMD activation.
5. Verbose messages must be enabled to ensure the text message is in a human
readable format. Tick the box adjacent to the relevant function.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales