Dedicated Mircros Digital Sprite 2 Guia de preparacion Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 130
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
Dedicated Micros ©2006
12
DS2 Network Guide
Note: Because the feed for this camera input will be delivered through the network, it is
recommended that you select an input that does not have a camera connected at the back
of the unit.
4. Change the Camera Type for the selected camera input to ‘IP’.
5. Repeat this operation for each of the IP feeds to be connected.
6. Click on Cameras->IP-Camera and Record Setup to congure each IP camera feed.
7. The camera type will be lled in for each of the selected IP cameras, logged against the
camera number that was selected.
8. Select the type of IP Camera. If the feed is coming from a NetVu Connected Server,
select NetVu Server.
9. Enter the URL of the IP video source in the next column.
10. If the video feed is coming from a NetVu Connected DVR, enter the camera number on
the source DVR that will be used as the feed for this IP camera input. If the source is an
IP camera, leave this column set at zero.
11. Enter the xx number into the IPCam Cam column.
12. Enter the Framerate that will be allocated to the camera. This should equate to the
camera’s internal setting.
Conguring the Network Settings of the unit
The unit can be allocated an IP address and associated settings via the serial port or OSD menus,
this web page allows these settings to be checked and changed if required.
To check / congure the network information:
1. Select Network -> Network Settings.
2. If the IP address, subnet mask and default gateway that has already been congured
via the serial port or OSD menus these will be displayed on this page, these can be
changed by entering the new information in the relevant areas.
3. The unit supports Domain Name Server allowing the unit to reference other hosts by
their name rather than their IP address, enter the IP address of the primary DNS and
secondary DNS server.
4. The default system name for the unit is DS2, this can be changed to a more appropriate
name by entering the information in this section.
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 129 130

Comentarios a estos manuales

Sin comentarios