Dedicated Mircros Digital Sprite 2 Guia de preparacion descargar pdf (Pagina 33)

DS2 Network Guide

15. If you want to use the default zone settings you can select the default grid option, this

will place 16 zones over the image. You will be presented with a prompt, select Yes.

16. Select the zone mode from the drop down box that will apply to the zone you have

selected see below for description of zone modes.

17. Set the pixel count (%) by selecting from the drop down box the range is between 2 and

100%.

18. Set the pixel change (%) by selecting a value from the drop down box the range is

between 2 and 100%,

An example of VMD operation:

Select the ‘zone area’ that will be congured and set the ‘pixel count’ to 20%, this

determines the percentage of pixels, in the selected zone, that must change for VMD to

be triggered. Set the ‘pixel change’ to 10%, this is the percentage value of the overall

change required in the greyscale.

19. To check you have covered the areas that you want to monitor for motion you can

select to view the zone areas only, select zone display only and you will be presented

with the areas you have highlighted.

20. Selecting full display will show the whole image.

21. Remember to save the conguration by select Save Settings!

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 129 130

Sin comentarios

Dedicated Mircros Digital Sprite 2 Guia de preparacion Pagina 33